Dumor MULTILAM 360-460-660 Dual 사용자 설명서 - 페이지 6

{카테고리_이름} Dumor MULTILAM 360-460-660 Dual에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dumor MULTILAM 360-460-660 Dual 12 페이지.

If you use the film stripper wheels you will need from time to time to remove the waste film or the cutters will

jam on the roll.

The wheels are a wear part

GUILDING REWINDER model only

The temperature should be set at the film makers specified temp, usually 110 - 120°C

A low speed should be selected.

NOTE that you can try guilding on grained surfaces but the guild many not penetrate fully into all the cracks

in the grain.

The machine is set up in the same way as single side lamination but without the anticurling being used.

The film is stripped from the sheet by the upper rewinder shaft and roller reeling in the used transfer film leaving

the guilded sheet to exit the machine free from the film.

The film has to be taped to the rewinder roll and at least one turn of the roll is done to enable a clean - wrinkle

free rewinding to take place.

ATTENTION that the film path is straight or wrinkles will ensue.

GUILDING/ SHEENING/ UV EFFECT /SL--KING TIPS

IMPORTANT

The substrate needs to be.

Flat no wrinkles or folds or bumps.

Smooth surface no surface effect.

Not porous or grainy.

At room temperature.

MACHINE SETTING

Medium braking on unwinder roll to eliminate wrinkles.

Medium tension on rewinder roll to pull out the film cleanly.

Speed 1

Highest pressure setting

Temp setting 120deg to 130 deg depending on substrate and film used