Aoi Electrical AOI0012 설치 매뉴얼 - 페이지 2

{카테고리_이름} Aoi Electrical AOI0012에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aoi Electrical AOI0012 6 페이지. Air bag control system 2004- 2009 dodge durango 2004-2012 ford crown vic 2004-2009 ford f150 2003-2010 ford explorer

페이지 인쇄

I. The following tools will be required to complete the installation.

A. Wire Strippers (24 AWG - 18AWG)

B. Soldering Iron

C. Heat shrink tubing (included)

D. Standard and Phillips Screwdriver

E. Socket Wrench with 7mm and 10mm sockets

II. Read all instructions carefully before starting the assembly process.

WARNING:

Never probe the electrical connectors on air bag, safety canopy or side air curtain modules.

Failure to follow this instruction may result in the accidental deployment of these modules, which

increases the risk of serious personal injury or death.

WARNING:

When performing service on or near the Supplemental Inflatable Restraint (SIR) components or

the SIR wiring, the SIR system must be disabled. Failure to observe the correct procedure could

cause deployment of the SIR components. Serious injury can occur. Failure to observe the correct

procedure could also result in unnecessary SRS system repairs. Consult OEM Dealer or Repair

Manuals for correct procedures.

III. Pre-Installation Procedure.

A. Verify that the SRS (Supplemental Restraint System) is functioning properly. Start the vehicle,

immediately after cranking the engine, locate the Air Bag Check light on the Dash Board. The light

should flash for approximately 6 – 8 seconds, then extinguish. Wait for another 6 – 8 seconds. The light

should NOT come back on.

aoielectrical.com

800.480.6680

THESE COMPONENTS ARE REQUIRED

TO INSTALL THE AOI AIR BAG CONTROL SYSTEM

AOI0011/12/14/ 15