Dunavox DAU-17.57DB 사용 설명서 - 페이지 5
{카테고리_이름} Dunavox DAU-17.57DB에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dunavox DAU-17.57DB 20 페이지.
Dunavox DAU-17.57DB에 대해서도 마찬가지입니다: 사용 설명서 (16 페이지)
페이지 인쇄
PRODUCT FEATURES
Built-in or Free-standing installation with single,
dual or three temperature zone, depending on
your model.
Continuously variable electronic temperature
control with digital display and touchpad input.
Temperature can be set from 5° to 22°C (40° to
72°F) for either compartment and can be
displayed in either Fahrenheit or Celsius degree.
Can be set to the long time storage maturing
temperature or a specific serving temperature
for red/white/sparkling wines.
Cooling and Heating to maintain the perfect
storaging and/or service condition.
Dynamic compressor type cooling to ensure
interior air circulation with even distribution of
temperature and humidity.
Soft white LED Interior Light with ON/OFF switch
– Function mode and Showcase mode.
Open-door and malfunction warning system.
Sabbath mode will allow the lights to remain off
during certain religious observances.
Temperature memory function - If power is
interrupted (power surge, breaker switch, etc.)
and then powered up again, the unit will operate
with the last temperature set-point.
Automatic
defrosting
evaporation.
Reversible tempered double/triple pane smoked
glass door protects your wine from UV light and
creates
an
attractive
condensation and low noise.
Black coated matte steel outer frame and black
plastic interior liner offer lifetime performance
and stability. The black liner prevents excessive
light from damaging the maturity process.
Optional stainless steel-framed glass door with
stainless steel handle.
Optional roll-out and adjustable solid varnished
beech shelves allow for maximum convenience
and flexibility to accommodate various size
bottles.
Environmentally friendly refrigerant and foaming
insulation gas.
Optional security lock system with keys.
Optional humidity control system (Humidity Box).
Optional active charcoal air filter.
NOTE: Features and specifications are subject to
change without notice.
Code Rev. D 20140818 (IEC)
with
defrost
water
display
with
few
INSTALLATION
BEFORE USING YOUR APPLIANCE
Remove all exterior and interior packing. Clean
the interior surface with lukewarm water using a
soft cloth. The unit may have residual odors at
first, they will disappear as the unit cools.
Before connecting the appliance to the power
source, let it stand upright for at least 24 hours.
This will reduce the possibility of a malfunction in
the cooling system caused by handling during
transportation. During this time we recommend
that you leave the door open to clear any
residual odors.
The door on this appliance can be opened from
either the left or the right side. The unit is
delivered with the door opening on the left side.
Should you wish to open the door from the right,
follow the instructions 'Reversing the door hinge'.
Install the handle on the door if necessary.
INSTALLATION OF YOUR APPLIANCE
The appliances are designed to be built-in or
recessed or free standing installation.
WARNING: Do not store or install the appliance
outdoors. The unit is for indoor use only.
WARNING: Do no install the appliance in the
laundry. Avoid locating the unit in damp areas.
Place your appliance on a floor that is strong
enough to support it when it is fully loaded. To
level your unit, adjust the front leveling leg at the
bottom of the unit.
For freestanding installation, 100mm of space
between the back and sides of the unit are
suggested,
circulation
to
condenser for energy saving. Even for built-in
installation, it is a must to keep 5mm space on
each side and at the top to ensure proper
service access and ventilation. Take care that
the air vent at the front of the appliance must
never be covered or blocked in any way.
Locate the unit away from direct sunlight and
sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and
heat
sources
5
which
allows
the
proper
cool
the
compressor
may
increase
air
and
electrical