Dunavox DAU-32.78DB 매뉴얼 - 페이지 8
{카테고리_이름} Dunavox DAU-32.78DB에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dunavox DAU-32.78DB 15 페이지.
Dunavox DAU-32.78DB에 대해서도 마찬가지입니다: 사용 설명서 (15 페이지)
페이지 인쇄
Climate class
Ambient room temperatures
SN
+10°C to +32°C
N
+16°C to +32°C
ST
+16°C to +38°C
T
+16°C to +43°C
NOTE:
Units with no heater will not raise their
internal temperature if the ambient temperature where
the unit is located is lower than the set temperature.
NOTE:
•
When you use the appliance for the first
time or restart the appliance after
having been shut off for a long time,
there could be a few degrees variance
between the temperature you select
and the one indicated on the LED
readout. This is normal and it is due to
the length of the activation time. Once
the unit is running for a few hours
everything will be back to normal.
•
If the unit is unplugged, power lost, or
turned off, you must wait 3 to 5 minutes
before restarting the unit. If you attempt
to restart before this time delay, the unit
will not start.
USE AND CONTROL (DAB-48.125B, SS;
DAU-52.146B, SS)
SINGLE ZONE
LIGHT
Control the interior light ON/OFF
RUN
When it's ON, the cooling system runs.
POWER
Control this appliance turn on/off. (press and hold this
button for approximately 3 seconds);
"UP" BUTTON
Press once the "UP" button, the temperature will raise
1ºC.
"DOWN" BUTTON
Press once the "DOWN" button, the temperature will
lower 1ºC.
"DISPLAY"
Display the set temperature indoor.
SETTING THE TEMPERATURE
You can set the temperature as you desire by pushing
the UP or DOWN button. When you push the two
buttons for the first time, the LED readout will show
the original temperature set at previous time.
The temperature that you desire to set will increase
1ºC if you push the UP button once, on the contrary
the temperature will decrease 1ºC if you push the
DOWN button once.
To view the "actual" temperature. (anytime) press and
hold the up or down button for approximately 5
seconds, the "actual" temperature will temporarily
"flash" in the LED display for 5 seconds.
The temperature setting can be adjusted from +5 ºC
to +18 ºC.
The temperature preset at the factory is +12 ºC.
USE AND CONTROL (DAU-46.146DB, DSS;
DAB-42.117DB, DSS; DX-89.246TB, TSS)
DUAL ZONE / TRIAL ZONE
LIGHT
Control the interior light ON/OFF
RUN
When it's ON, the cooling system runs.
POWER
Control this appliance turn on/off. (press and hold this
button for approximately 3 seconds);
"Set Upper" Button
To set the temperature of the upper chamber.
"Set Lower" Button
To set the temperature of the lower chamber.
"Upper Chamber"
Display the set temperature in upper compartment.
"Lower Chamber"
Display
the
in
lower compartment.
actual
temperature