Dunavox DAU-52.146B 사용 설명서 - 페이지 4
{카테고리_이름} Dunavox DAU-52.146B에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dunavox DAU-52.146B 10 페이지.
Dunavox DAU-52.146B에 대해서도 마찬가지입니다: 사용 설명서 (15 페이지), 매뉴얼 (15 페이지)
페이지 인쇄
OPERATING YOUR WINE COOLER AND SETTING THE TEMPERATURE
Control System Instruction
LIGHT
Control the interior light ON/OFF
RUN
When it's ON, the cooling system runs.
POWER
control this appliance turn on/off. ( press and hold this buttons for approximately
3 seconds);
"UP" BUTTON
Press once the "UP" button, the temperature will raise 1 ℃.
"DOWN" BUTTON
Press once the "DOWN" button, the temperature will lower 1 ℃.
"DISPLAY"
Display the actual temperature indoor.
Setting The Temperature Controls
You can set the temperature as you desire by pushing the UP or DOWN button. When you
push the two buttons for the first time, the LED readout will show the original temperature
set at previous time.
The temperature that you desire to set will increase 1ºC if you push the UP button once, on
the contrary the temperature will decrease 1ºC if you push the DOWN button once.
To view the "set" temperature. (anytime) press and hold the corresponding button for
approximately 5 seconds, the "set" temperature will temporarily "flash" in the LED display
for 5 seconds.
The temperature setting can be adjusted from 5℃ to 18℃.
The temperature preset at the factory is 12℃.
Attention
If the unit is unplugged, power lost, or turned off, you must wait 3 to5 minutes before
restart the unit. If you need attempt to restart before this time delay, the Wine cooler will
not start. If first time use or longer absence of using, the temperature will difference
between setting and LED display temperature. After running a period, the temperature will
be reverting back.
In order to reduce energy consumption, this wine cabinet will automatically switch off the
LED lights after 10 minutes. If you want the LED light to remain on continuously, this is
possible. Please press and hold the "LIGHT" button for 5 seconds, the display will show
"LP". After 4 seconds the display will revert back to normal and the light will remain on until
manually switched off. If you want to revert back and conserve energy (recommended),
please press and hold the "LIGHT" button for 5 second, the display will show "LF", after 4
seconds the display will revert back to normal, and the light will automatically switch
off after 10 minutes.
CONTROL
4