Aolait 12x30w Led Moving Bar RGBW 4 in 1 light. 사용자 설명서 - 페이지 7

{카테고리_이름} Aolait 12x30w Led Moving Bar RGBW 4 in 1 light.에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aolait 12x30w Led Moving Bar RGBW 4 in 1 light. 17 페이지.

페이지 인쇄

6. DMX-512 Signal Connection

Connect the supplied XLR cable to the female 3-pin of the controller. The other side of

the XLR output is the male 3-pin XLR input of the moving head. (The 5-pin connection

is similar) You can link multiple moving heads together via a serial link. The required

cable should be a two-core shielded cable connector with XLR inputs and outputs.

Please refer to the figure below.。

DMX-512 connection with DMX termination

For installations where the DMX cable must be operated over long distances or

electrically operated in a noisy environment, such as in a disco, DMX termination is

recommended. This helps prevent electrical damage to the digital control signal noise.

The DMX terminator is only connected between the XLR plug pins 2 and 3 of the 120Ω

resistor and then inserted into the output of the last fixture. The XLR socket is in the

chain. Please see the illustration below.