Aolait ALED BSW CMY 400 사용자 설명서 - 페이지 3

{카테고리_이름} Aolait ALED BSW CMY 400에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aolait ALED BSW CMY 400 20 페이지.

Operate the device only after having familiarized with its functions. Do not permit

operation by persons not qualified for operating the device. Most damages are the result

of unprofessional operation.

Please use the original packaging if the device is to be transported.

For safety reasons, please be aware that all modifications on the device are forbidden. If

this device will be operated in any way different to the one described in this manual, the

product may suffer damages and the guarantee becomes void. Furthermore, any other

operation may lead to short-circuit, burns, electric shock, crash, etc.

SAFETY INSTRUCTIONS

Be careful with your operations. With a dangerous voltage you can suffer a

dangerous electric shock when touching wires!

This device has left the factory in perfect condition. In order to maintain this condition and

to ensure a safe operation, it is absolutely necessary for the user to follow the safety

instructions and warning notes written in this user manual.

1. In order to guarantee the product's life, please don't put it in the damp places or even

the environment over 60degress.

2. Always mount this unit in safe and stable matter.

The qualified professionals are allowed to carry out the lamp installation, operation and

maintenance, but they must guarantee to operate in strict accordance with the instructions

referred to.

Important:

▲

Damages caused by the disregard of this user manual are not subject to

warranty. The dealer will not accept liability for any resulting defects or

problems.

If the device has been exposed to temperature changes due to environmental changes,

do not switch it on immediately. The arising condensation could damage the device. Leave

the device switched off until it has reached room temperatures.

This device falls under protection-classⅠ. Therefore it is essential that the device be

earthed.

The electric connection must carry out by qualified person.

Make sure the power cord is never crimped or damaged by sharp edges. If this would be

the case, replacement of the cable must be done by an authorized dealer.

Always disconnect from the mains, when the device is not in use or before cleaning it.

Only handle the power cord by the plug. Never pull out the plug by tugging the power cord.

During initial start-up some smoke or smell may arise. This is a normal process and does

not necessarily mean that the device is defective, it should decrease gradually.

Please don't project the beam onto combustible substances.

If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively

replaced by the manufacturer or his service agent or a similar qualified person in order to

avoid a hazard.

CAUTION!