Dunavox DX-16.46K 사용 설명서 - 페이지 8

{카테고리_이름} Dunavox DX-16.46K에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dunavox DX-16.46K 14 페이지. Compressor driven
Dunavox DX-16.46K에 대해서도 마찬가지입니다: 운영 매뉴얼 (8 페이지), 사용 설명서 (8 페이지)

페이지 인쇄

5.2. Installation of Your Wine Cooler

This Wine Cooler is designed to be free standing installation or built under counter.

Place your Wine Cooler on a surface that is strong enough to support it when it is fully loaded.

Allow 1-5 cm of space between the back and sides of the Wine Cooler, which allows the

proper air circulation to cool the heat sink.

Locate the Wine Cooler away from direct sunlight and sources of heat (stove, heater, radiator,

etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical

consumption. Extreme cold ambient temperatures may also cause the unit not to perform

properly.

Avoid locating the unit in moist areas.

Plug the Wine Cooler into an exclusive, properly installed-grounded wall outlet. Do not under

any circumstances cut or remove the third (ground) prong from the power cord. Any questions

concerning power and/or grounding should be directed toward a certified electrician or an

authorized service center.

After plugging the Wine Cooler into a wall outlet, allow the unit to cool down for 2-3 hours

before placing any items in the compartment.

Rest the wine cooler for 24 hours after transportation.

5.3. Electrical Connection

Warning

This appliance should be properly grounded for your safety. The power cord of this appliance

is equipped with a three-prong plug which mates with standard three prong wall outlets to

minimize the possibility of electrical shock.

Do not under any circumstances cut or remove the third ground prong from the power cord

supplied. For personal safety, this appliance must be properly grounded.

This appliance requires a standard 220-240 Volt AC / 50Hz electrical ground outlet with three-

prong. Have the wall outlet and circuit checked by a qualified electrician to make sure the

outlet is properly grounded. When a standard 2-prong wall outlet is encountered, it is your

responsibility and obligation to have it replaced with a properly grounded 3-prong wall outlet.

The cord should be secured behind the appliance and not left exposed or dangling to prevent

accidental injury.

The appliance should always be plugged into its own individual electrical outlet which has a

voltage rating that matches the rating label on the appliance. This provides the best

performance and also prevent overloading house wiring circuits that could cause a fire hazard

from overheated. Never unplug the appliance by pulling the power cord. Always grip the plug

firmly and pull straight out from the receptacle. Repair or replace immediately all power cords

that have become frayed or otherwise damaged. Do not use a cord that shows cracks or

abrasion damage along its length or at either end. When moving the appliance, be careful not

to damage the power cord.

INSTRUCTION MANUAL

Improper use of the grounded plug can result in

the risk of electrical shock. If the power cord is

damaged, have it replaced by an authorized

service center.