AOLYNK DR Series 빠른 설치 매뉴얼
{카테고리_이름} AOLYNK DR Series에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AOLYNK DR Series 2 페이지. Adsl2+ routers
페이지 인쇄Aolynk DR Series ADSL2+ Routers
Quick Installation Manual
1
Appearance
Figure 1 Aolynk DR8XX front view
Figure 2 Aolynk DR8XX rear view
2
Packing list
One router of Aolynk DR series
l
One power adapter
l
One telephone cable
l
One Ethernet cable
l
One USB cable
l
Two screws and two anchors
l
One Quick Installation Manual
l
One CD
l
Certificate of Quality
l
3
Hardware Installation
3.1 Installation Precautions
Leave enough space (about 10 cm) around the router for heat
l
dissipation.
Fix the router and power adapter well for wall-mounting the
l
router.
3.2 Installing ADSL Line
Aolynk ADSL2+ Router
LINE
Splitter
ADSL
PHONE
Desktop PC
NoteBook
Figure 3 Installing ADSL line
Two options are available for ADSL line connections:
Direct connect the ADSL line (same as a regular telephone port)
l
to the wall telephone line outlet.
As shown in Figure 3 , Connect the ADSL port and a telephone
l
set to a splitter, and then the splitter to the wall outlet of
telephone line. Thus you may place phone calls when accessing
the Internet.
3.3 Connecting to PC or Ethernet
You can use crossover or straight-through cables to connect the PC, HUB, or
switch to the MDI/MDIX auto-sensing interface of DR series router.
3.4 Connecting the Power Cord
1) Attach one end of the power cord to the router and the other end to
power outlet. The power cord is accessory of the router.
2) Observe the LED status one minute later. The following table lists the
LEDs and their normal expected status.
Table 1 LEDs
LED
Power
The LED stays green. Check the power cord connection if the LED stays off.
Telephone port
Link
The blinking of the LED indicates the ADSL activation and 20 to 30 seconds
later, the LED stays green.
LAN
The green LED stays on. The blinking of the green LED indicates the data
transmission on the Ethernet port.
Diag
This LED is off. If this LED turns on, contact the agents for help.
3.5 Configuring to Obtain an IP address automatically
Telephone
Take the operation in the Windows 2000/XP operating system for example.
The steps are as follows:
1) Click the <Start> button and choose the Settings > Control Panel options.
Double-click on the Network Dial-up Connections icon from the Control
Panel window.
2) Right-click on the Local Area Connection icon and select the Properties
from the pop-up menu. Next, choose the Internet Protocol (TCP/IP) from the
Local Area Connection Properties tabbed interface and click <Properties> to
proceed.
3) When the Internet Protocol (TCP/IP) Properties interface pops up, select
the Obtain an IP address automatically and Obtain DNS server address
Normal status