Duncan Convertible 2000 소유자 매뉴얼 - 페이지 5

{카테고리_이름} Duncan Convertible 2000에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duncan Convertible 2000 19 페이지.

Installing & Changing Preamp Modules.

Installing modules is quick and easy. Plug the modules into their receptacles located under the"

Quick Access" plate on the top of the amp.

To install your modules just follow these easy steps:

1. Choose the module arrangement you wish to try. (See pages 4-5 for some ideas or the

instruction sheet in your module pack for the suggested order of installation.)

2. Choose the module you want to install and grasp it by its handle.

3. Insert the new module through the "Quick Access "module system opening. It may be

necessary to tilt the module forward before it will fit through the opening. This may seem awkward

at first, but it becomes as easy as changing a cartridge in a video game.

4. Align the module plug to be installed over the receptacle in the position you've chosen.

5. Slowly insert the module connector into the receptacle. Apply moderate pressure until you feel

the module is seated snugly.

6. Repeat steps 2 thru 5 for each module you are installing. When you have finished installing

modules, double check all modules to ensure they are still snug in their receptacles.

7. Align the "Quick Access" cover with the holes in the top of the amplifier cabinet and secure. If

your amp is plugged in and the Standby switch is set, your amp will automatically be turned on

into the "Standby" mode. Give it a minute or two to warm up completely, flip the switch to "On"

and you're ready to play.

*Note: Amplifier will not operate without the module access panel securely fastened. (This

depresses the safety shutoff switch.)

To remove:

1.Turn the "Quick Access" plate screws counter-clockwise. They will pop up.

2. Remove the plate. When this is done, it will automatically shut down the amp.

3. Looking down inside the amplifier, firmly grasp the module you want to replace by its handle

and lift slowly. When the module is free from its receptacle, continue to lift upward. You may have

to turn the module sideways to clear the module opening.