Danfoss VLT FC 103 설치 매뉴얼 - 페이지 14

{카테고리_이름} Danfoss VLT FC 103에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss VLT FC 103 20 페이지. Igbt module replacement for d1h–d8h drives
Danfoss VLT FC 103에 대해서도 마찬가지입니다: 운영 매뉴얼 (16 페이지), 설치 지침 매뉴얼 (6 페이지), 설치 매뉴얼 (18 페이지), 설치 지침 매뉴얼 (8 페이지), 설치 지침 매뉴얼 (10 페이지), 설치 매뉴얼 (6 페이지), 사용 설명서 (16 페이지), 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (8 페이지), 설치 지침 매뉴얼 (6 페이지), 설치 매뉴얼 (6 페이지)

Installation

Wiring procedure for enclosure sizes A4–A5, B1–B4, and

C1–C4

Push the cable through cable glands.

Mount the fieldbus connector on the fieldbus

option (terminals 62, 63, 66, and 67).

Prepare the fieldbus cable by stripping a section

of the cable insulation. Keep the unshielded wire

as short as possible. For cable specifications, refer

to chapter 3.7.2 Cable Specifications. For fieldbus

cable requirements, see chapter 3.7.3 Bus Segment

Requirements.

Connect the fieldbus cable wires to the terminals

according to the colour code of the wires, see

Illustration 3.10.

Fix the cable screen to the metal base plate using

cable clamp or cable tie, see Illustration 3.11.

Tighten cable glands securely.

Illustration 3.11 Wiring for Enclosure Sizes A4–A5, B1–B4, and

C1–C4

VLT

PROFIBUS DP MCA 101

Wiring procedure for enclosure sizes D, E, and F

Illustration 3.12 Wiring for Enclosure Sizes D, E, and F

Mount the fieldbus connector on the fieldbus

option (terminals 62, 63, 66, and 67).

Prepare the fieldbus cable by stripping a section

of the cable insulation. Keep unshielded wire as

short as possible. For cable specifications, refer to

chapter 3.7.2 Cable Specifications. For fieldbus

cable requirements, see chapter 3.7.3 Bus Segment

Requirements.

Connect the fieldbus cable wires to the terminals

according to the colour code of the wires, see

Illustration 3.10.

Fix the cable screen to the metal base plate using

cable clamp or cable tie, see Illustration 3.12.

Tie down the cable and route it with other

control wires inside the unit, see Illustration 3.12.

MG33C602