Casio 2226-2 사용자 설명서

{카테고리_이름} Casio 2226-2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Casio 2226-2 2 페이지. Casio watch user manual

페이지 인쇄

Module No. 2226

• Press C C to change from mode to mode.

• In any mode (except when making countdown alarm settings) press D D to illuminate the digital display.

Timekeeping Mode

TIMEKEEPING MODE

Day of

Month

Day

week

Hour

Seconds

Minutes

indicator

4. While any other setting (beside seconds) is selected (flashing), press E E to increase

it or B B to decrease it. While the 12/24-hour format setting is selected, press E E to

toggle it between 12 and 24.

• Except for the seconds or 12/24-hour setting, holding down a button changes the

setting at high speed.

• When the 12-hour format is selected, the indicator P appears on the display to

indicate "P.M." times. There is no indicator for "A.M." times.

5. After you set the time and date, press A A to return to the Timekeeping Mode.

• The day of the week is automatically set in accordance with the date.

• The date can be set within the range of January 1, 1995 to December 31, 2039.

• If you do not operate any button for a few minutes while a setting is flashing, the

flashing stops and the watch goes back to the Timekeeping Mode automatically.

ABOUT THE BACKLIGHT

About the Auto Light Switch Function

When the auto light switch function is turned on, the backlight automatically turns on

for two seconds under the conditions described below. Avoid wearing the watch on the

inside of your wrist. Doing so causes the auto light switch to operate when not needed,

which shortens battery life.

Moving the watch to a position that is parallel to the ground and then tilting it towards

you approximately 40 degrees causes the backlight to illuminate.

• The backlight may not illuminate if the face of the watch is more than 15 degrees off

parallel to the left or right. Make sure that the back of your hand is parallel to the

ground.

Parallel to ground

• Static electricity or magnetic force can interfere with proper operation of the auto

backlight function. If the auto backlight does not illuminate, try moving the watch

back to the starting position (parallel with the ground) and then tilt it back toward you

again. If this does not work, drop your arm all the way down so it hangs at your side,

and then bring it back up again.

• Under certain conditions the backlight may not light until about one second or less

after turn the face of the watch towards you. This does not necessarily indicate

malfunction of the backlight.

To switch the auto light switch function on and off

In the Timekeeping Mode, hold down E E for one or two seconds to turn the auto light

switch function on and off.

Stopwatch Mode

To set the time and date

1. Hold down A A while in the Timekeeping Mode

until the seconds digits flash on the display.

2. Press C C to change the selection (flashing) in the

following sequence.

Seconds

Hour

Minutes

Day

Month

Year

3. While the seconds setting is selected (flashing),

press E E to reset it to 00. If you press E E while the

seconds setting is in the range of 30 to 59, the

seconds are reset to 00 and 1 is added to the

minutes. If the seconds setting is in the range of

00 to 29, the minutes count is unchanged.

Parallel to

ground

40°

More than 15 degrees

too high

too low

Auto light switch

indicator

Hold down E E .

OFF

GENERAL GUIDE

• The auto light switch indicator is shown on the display in all modes while the auto

light switch function is on.

• In order to protect against running down the battery, the auto light switch function is

automatically turned off approximately three hours after you turn it on. Repeat the

above procedure to turn the auto light switch function back on if you want.

• Pressing D D at any time illuminates the display, regardless of the auto light switch's

on/off setting.

12/24-Hour

Caution

Format

• The backlight of this watch employs an electro-luminescent (EL) light, which loses its

illuminating power after very long term use.

• Frequent use of the backlight shortens the battery life.

• The watch emits an audible sound whenever the display is illuminated. This is because the

EL light vibrates slightly when lit. It does not indicate malfunction of the watch.

Warning!

• Never try to read your watch when mountain climbing or hiking in areas that are dark

or in areas with poor footing. Doing so is dangerous and can result in serious

personal injury.

• Never try to read your watch when running on a roadside or in any other location

where there might be vehicular or pedestrian traffic. Doing so is dangerous and can

result in serious personal injury.

• Never try to read your watch when riding on a bicycle or when operating a motorcycle

or any other motor vehicle. Doing so is dangerous and can result in a traffic accident

and serious personal injury.

• When you are wearing the watch, make sure that its auto light switch function is

turned off before riding on a bicycle or operating a motorcycle or any other motor

vehicle.

Sudden and unintended operation of the auto light switch can create a distraction,

which can result in a traffic accident and serious personal injury.

About the EL Alarm

While the EL alarm feature is turned on, the watch's EL backlight flashes along with

the audible tone when a daily alarm time is reached, when the hourly time signal

sounds, or when the end of a countdown alarm operation is reached. Pressing D D

while the EL alarm feature is turned on causes the display to remain illuminated for

five seconds, instead of the normal two seconds when the EL alarm is turned off.

To turn the EL Alarm feature on and off

• In the Timekeeping Mode, hold down B B until the EL Alarm indicator appears on (EL

alarm on) or disappears from (EL alarm off) the display.

Mode indicator

Hours

Elapsed time measurement

E E

Start

Split time measurement

E E

Start

Split time and 1st-2nd place times

E E

Start

Countdown

Alarm Mode

EL Alarm indicator

Hold down B B .

STOPWATCH MODE

The Stopwatch Mode lets you measure elapsed

1/100

time, split times, and two finishes. The range of the

seconds

stopwatch is 23 hours, 59 minutes, 59.99 seconds.

You can use the EL backlight at any time while the

stopwatch is operating.

Seconds

Minutes

E E

Stop

Re-start

B B

Split

Split release

B B

E E

Split

Stop

First runner

Second runner

finishes.

Record time of

first runner.

2226-1

Alarm Mode

OFF

E E

B B

Stop

Clear

E E

B B

Stop

Clear

B B

Split release

Clear

Record time of

second runner.