3T-Components 3T-MOTORS 3T35-13R 설치 및 운영 지침 매뉴얼 - 페이지 17
{카테고리_이름} 3T-Components 3T-MOTORS 3T35-13R에 대한 설치 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3T-Components 3T-MOTORS 3T35-13R 20 페이지. Radio shutter / awning motors with mechanical limit switches
3T-Components 3T-MOTORS 3T35-13R에 대해서도 마찬가지입니다: 설치 및 운영 지침 매뉴얼 (20 페이지)
페이지 인쇄
PROGRAMMING RADIO TRANSMITTER
Delete handheld transmitter:
Attention! Deleting the handheld transmitter
deletes all paired transmitters on the radio motor.
Leave Power supply
switched on.
Only switch the affected
motor to voltage.
Switching the operating mode
Shutter and Blind:
Leave Power supply
switched on.
Only switch the affected
motor to voltage.
This setting allows switching from Shutter mode and Blind mode and vice versa.
Shutter operating mode: Motor immediately goes into self-hold when a direction button is pressed.
Blind operating mode: Jog mode possible. Only when the direction key is pressed for longer than 2 sec. Self-holding is carried out.
Note:
The following 3T-MOTORS transmitters do not have a P2 / Set Up button:
Radio mini transmitter
Radio wall transmitter
FMSF
Button combination:
Press Up + Stop buttons simultaneously (FMSF / WS1 / WS2 / WSE2).
Press the Set and Mode buttons simultaneously (WSTF1 / WSTF5).
Beep while
pressing
1 x Press button
P2 / Set Up
Stop-button
Beep while
pressing
1 x Press button
P2 / Set Up
Up-button
Radio wall transmitter
WS1
WS2
Programming (pressing the buttons) must be carried out within 10 seconds.
Otherwise the motor returns to its original state.
Beep while
pressing
1 x Press
1 x Press button
P2 / Set Up
Programming (pressing the buttons) must be carried out within 10 seconds.
Otherwise the motor returns to its original state.
Beep while
pressing
1 x Press
1 x Press button
P2 / Set Up
Radio wall transmitter
WSE2
OK
The motor confirms
the programming
OK
The motor confirms
the programming
Radio timer
WSTF1
3T-MOTORS Radio tubular motors | Programming radio transmitter
with several
beeps
with several
beeps
Radio timer
WSTF5
17