Danfoss BasicPlus2 WT-DM 설치 매뉴얼 - 페이지 2

{카테고리_이름} Danfoss BasicPlus2 WT-DM에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss BasicPlus2 WT-DM 11 페이지. Room thermostats for floor heating
Danfoss BasicPlus2 WT-DM에 대해서도 마찬가지입니다: 사용자 설명서 (4 페이지)

페이지 인쇄

Installation Guide

WT-DM Installation Instruction

Installation Steps

The User Guide can be downloaded from: heating.danfoss.com.

1. Installation must be done by an authorised electrician.

2. The room thermostat should be installed at approx. 1.5 m

above oor and where the e ects of sunlight, draught or

other heat sources (eg. TV's) are avoided. See g.1.

3. First of all, carefully remove the cover. See g.2.

4. Connect the wire before mounting the back plate to the

wall box using the enclosed screws. Then mount the cover

to the back plate. See g.3.

Wiring

1. Dimensions, see g.4.

2. Wiring diagram,see g.5. (S1,S2: oor sensor terminals;A+,B-:

Modbus communication terminals).

3. WT-DM is often used with Danfoss TWA actuator. Depending

on the conditions of power location and actuator type (NC or

Danfoss Heating Solutions