3T-Components 3T-MOTORS 3T45-10SD 설치 및 운영 지침 매뉴얼 - 페이지 7
{카테고리_이름} 3T-Components 3T-MOTORS 3T45-10SD에 대한 설치 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3T-Components 3T-MOTORS 3T45-10SD 16 페이지. Shutter motors with mechanical limit switches, for shafts from 60/40 mm
페이지 인쇄
INSTALLATION INSTRUCTIONS
Please note:
The motor can be installed on the right-hand side as well as on the left-hand side.
•
If the direction of rotation is reversed, please exchange the wires for the up and down direction.
The setting of the end positions is only possible in the installed state (motor in shutter shaft).
•
Never place screws in the area of the tube motor, as they will damage the motor.
•
Engine damage caused by improper use or unprofessional installation,
•
lead directly to loss of warranty.
INSTALLATION SHUTTER MOTOR
Installation situation
1
Counter
bearing*
2
Ball
bearing*
3
Roller
capsule*
4
Shutter
shaft*
5
Suspension
spring*
6
Shaft adapter
7
Tubular motor
8
Limit switch adapter
10
Limit switches
10
Engine mount
11
Shutter
curtain*
*
Accessories; not included
Prepare power connection:
1
The mains connection cable of the drive must be laid internally in the empty conduit up to the junction box.
•
The local electrical regulations must be observed.
Select motor bearing:
2
Two motor bearings are supplied: Universal bearing and bracket + cover cap bearing (3T45-SD) / clip bearing (3T35-SD).
•
Use one of the two motor bearings depending on the installation situation.
•
1
2
3
4
5
6
7
3T-MOTORS Tubular motors | Installation instructions
8 9 10
11
7