Danfoss FP715Si 설치 매뉴얼 - 페이지 7

{카테고리_이름} Danfoss FP715Si에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss FP715Si 20 페이지. Electronic 2-channel full programmer for heating and hot water with service interval timer
Danfoss FP715Si에 대해서도 마찬가지입니다: 사용자 지침 (2 페이지)

페이지 인쇄

Option 8 - (Advanced Copy Functions)

Press NEXT, then + or - to change between the following copy

options:

(0) Standard copy in 7 day and 5+2 day.

(1) Enhanced copy in 7 day and 5+2 day.

(2) Enhanced copy in 7 day and AB copy in 5+2 day.

For an explanation of the copy features and how to use them please

see below.

Press PROG to return to RUN.

5.0 Copy Functions Explained

There are 3 possible copy functions available. These are; Standard

Copy, Enhanced Copy, and AB copy. Copy functions are enabled/

disabled in the Advanced Programming Options (page 6).

Standard Copy: Pressing copy will copy the previous days events

into the displayed day. The unit will then display the 1st event for the

new day. This copy function is present only if the unit is set to run in

5+2 or 7 day mode.

Enhanced Copy: The enhanced copy function is available in 7 day

mode only. This allows any day to be copied to any other day, or days.

To use the enhanced copy function go into the event programming

using the PROG button, then:

1. Use the DAY button to ﬁ nd the day to be copied from.

2. Press the COPY button to select the day to be copied from. When

selected, the day should begin to ﬂ ash.

3. Use the DAY button to ﬁ nd the day to be copied to.

4. Press COPY button to copy the selected day.

5. Repeat steps 3 and 4 to select and copy other days.

6. To stop copying, use the DAY button to go back to the ﬂ ashing

day and press the COPY button. The previously ﬂ ashing day will

stop ﬂ ashing to indicate it has been de-selected.

NOTE: When a day has been copied to, it will remain visible and not

ﬂ ashing when the DAY button is used to select other days.

Danfoss Heating