Danfoss FP735Si 설치 매뉴얼 - 페이지 6

{카테고리_이름} Danfoss FP735Si에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss FP735Si 20 페이지. Electronic 3-channel full programmer for heating and hot water with service interval timer
Danfoss FP735Si에 대해서도 마찬가지입니다: 빠른 매뉴얼 (4 페이지), 쉬운 사용자 설명서 (2 페이지)

페이지 인쇄

3.4 Mount the unit on the wallplate

3.5 With the unit powered up, it is recommended to press and

release the RESET button to start up the FP735Si unit.

4.0 Programming Options

FP735Si is delivered with a set of parameters that have been pre-

programmed to cover the most typical type of installations. See

(5.0). If a diff erent parameter setup is wanted the unit provides two

programming options:

4.1

Normal programming

Normal Programming is meant for setting the timing profi le that

controls the ON and OFF periods for the room heating and for the hot

water. A daily profi le may be programmed and a profi le can control

the entire week where the weekend may be handled separately. Also a

timing profi le for a holiday can be entered.

As part of the normal daily operations, a simple one-button press

(+HRS) can extend a running ON period for room heating and/or hot

water by one hour. This can be repeated 3 times giving up to 3 hours

extension.

Note: Always switch

the mains off fi rst

and never fi t/remove

the timer to/from a

live wallplate.

FP735SI