Danfoss REP24CO 설치 지침 매뉴얼 - 페이지 6

{카테고리_이름} Danfoss REP24CO에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss REP24CO 8 페이지. Electronic proportional heat / cool thermostat with manual heat/cool selection

페이지 인쇄

Locking & limiting

To lock or limit the setting range turn the setting dial to 3 and

remove knob.

Position the locking springs on the rear of the dial to the

desired position and re-mount the knob ensuring that

number 3 on the dial aligns with the reference mark on the

case.

User Instructions

Setting the temperature

Turn the setting dial to the required temperature.

Frost Protection

To activate frost protection, turn the dial below 10°C. Frost

protection becomes active at 8°C. If the temperature in the room

drops below 8°C then the output will activate.

When frost protection is activated the right LED will turn orange.

Standby Mode

In cooling mode, the standard frost protection is not available;

instead there is standby mode. When the dial is turned past 10°C

the unit enters standby mode and cooling will be inactive until the

dial is turned up past 10°C.