Danfoss RET2001 사용자 설명서 - 페이지 3

{카테고리_이름} Danfoss RET2001에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss RET2001 4 페이지. Digital room thermostat

페이지 인쇄

User Guide

Frost Protection Temperature and Reset

• You can switch the thermostat OFF (Standby) by alternately pressing

stat is set to a Frost Protection temperature setting and will switch On only if the measured temperature falls

below this temperature (5 °C by default).

• The frost protect icon and current temperature will be displayed.

• At this point, if the

Set Control Parameters

• Press M button for 6 seconds to enter the parameter setting mode. Press M for parameter selection and set

the parameter range via < or >. Complete all adjustments.

• To exit press upper part of setting ring or wait 20 secs for automatic exit.

The digits indicate the set value as follows:

No.

Parameter settings

P02

Heat control mode

P04

Temperature limit high

P05

Temperature limit low

P06

Frost protect temperature

P07

Away mode temperature

P10

RF Pairing (RET2001RF only)

Error Messages

Sensor failure

EEPROM failure

Measured temperature below 0 °C

Measured temperature above 50 °C

RF Pairing failed

RF Signal lost

Danfoss Heating

RET2001 Digital Room Thermostats

button is pressed for 10 seconds Continuously then the thermostat will be reset.

01: On/off load compensation

02: On/off standard

Between low (P05) and 35 °C

Between 5 °C and high (P04)

Between 5 °C and 15 °C

Between low (P05) and high (P04)

00: RF pairing mode off

01: RF pairing mode on

. In OFF (Standby) mode, the thermo-

Settings range

VUSUD102

Default

35 °C

5 °C

18 °C

08/2020