Danfoss RT52 설치 지침 매뉴얼 - 페이지 5

{카테고리_이름} Danfoss RT52에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss RT52 11 페이지.
Danfoss RT52에 대해서도 마찬가지입니다: 설치 지침 (4 페이지)

Commissioning (RF models only)

If the thermostat and the receiver have been supplied together

in a combined pack, the units have been paired in the factory

and no commissioning is required (RX1 only).

To tune the RX receiver to the frequency of the thermostat signal,

follow steps 1-5 below.

Step 1 RT51/52-RF

Reset the unit by removing the

batteries for minutes, then replace.

Step 2 Press and hold V and +

buttons for 3 seconds (Thermostat now

transmits unique signal continuously

for 5 minutes).

Step 3 RX1

Press and hold buttons PROG and CH1

for 3 seconds until green light flashes

once.

Step 4 RX2 (if applicable)

Stat 1 - perform steps 1-3.

Stat - wait 5 mins, perform steps 1- and

then press PROG and CH2 on RX2.

RX3 (if applicable)

Stat 1 - perform steps 1-3.

Stat - wait 5 mins, perform steps 1- and then press PROG and

CH2 on RX3.

Stat 3 - wait 5 mins, perform steps 1- and then press PROG and

CH3 on RX3.

Step 5 RT51/52-RF

Press Λ or V to select temperature - unit will revert back to operating

mode.