Danfoss TP5001 series 간편한 설정 매뉴얼 - 페이지 2
{카테고리_이름} Danfoss TP5001 series에 대한 간편한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss TP5001 series 2 페이지. Programmable room thermostat
Danfoss TP5001 series에 대해서도 마찬가지입니다: 사용자 설명서 (4 페이지)
페이지 인쇄
Setting On and Off times:
st
To set the 1
period of the day ( ) Press the
seconds. Display changes to show Mon, Tue, Wed, Thu, Fri
with the HOUR flashing. Use < or > to set the HOUR of your
first temperature event. Press
Use < or > to set the MINUTES.
Press
and the display will change to show TEMPERATURE
flashing. This is the TEMPERATURE you want the room at for
the first period of the day. Use < or > to adjust the
TEMPERATURE e.g. 21
two ( ).
The display now shows period two ( ) with the HOUR
flashing. Use < or> to select the time you wish period ( ) to
start. Press
to set the MINUTES using < or > buttons. Press
to confirm and then use < or > to set the required
TEMPERATURE e.g. 16
steps to set the period 3 ( )and 4 ( )
Once periods
and
to show SAT SUN. Repeat previous processes to set the time
and temperature events for the weekend.
Once the temperature has been set for period
button, the display will revert to its normal operating display
NOTE: If your unit is set for 24hr programming, the display will show Mon Tue Wed Thu Fri Sat Sun during
programming and all days will have the same times and temperatures set. This is changed in the advanced setting,
Away Mode:
Away mode is used to temporarily stop the timing functions if
you are away for a period of time.
To enable AWAY mode, press M button and a
in the display.
The AWAY mode temperature is set to 16
change, consult full user instructions.
To disable AWAY mode, press and release M button – normal
programme times are resumed.
Instruction
to make the MINUTES flash.
o
C. Press
to set and move to period
o
C. Press
and repeat the previous
have been set, the display will change
see the full user guide for further instruction.
o
C by default. To
button for 5
using
will appear
Buttons Used
< >
< >
< >
< >
M
M
Screen Display