Danfoss TP7000 Series 설치 지침 사용자 지침 - 페이지 8
{카테고리_이름} Danfoss TP7000 Series에 대한 설치 지침 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss TP7000 Series 14 페이지. Electronic programmable room thermostat
Danfoss TP7000 Series에 대해서도 마찬가지입니다: 사용자 설명서 (11 페이지), 설치 지침 매뉴얼 (9 페이지)
페이지 인쇄
- 1. Installation Instructions
- 2. Specification
- 3. Installation
- 4. DIL Switch Settings
- 5. Your Programmable Room Thermostat
- 6. Preset Programmes
- 7. Before You Start
- 8. Display Preferences
- 9. Setting the Clock & Day
- 10. Setting the OSC Period
- 11. Accepting the Preset Programmes
- 12. Before You Change the Preset Programmes
- 13. Programming in 7-Day Mode
- 14. To Convert to Thermostat Mode
- 15. To Programme Holiday Mode
- 16. User Overrides
Display preferences
Temperature display (°C or °F)
Press and hold DAY & COPY (for 2-3
seconds) until display changes.
Clock display (12 or 24 hr)
Press and hold NEXT & DAY (for 2-3
seconds) until display changes
(AM or PM will appear in 12 hr mode)
Setting the Clock & Day
Press PROG to begin programming
DAY - Press DAY until correct day is
shown (1=Monday, 2=Tuesday etc)
To change TIME
TIME - Press + and - to change time
To
(press and hold to change in 10 min
change
increments)
DAY
Setting the OSC Period,
if enabled (see pg.5)
This display will ONLY appear if the OSC
function has been enabled by your installer.
Use the + or - buttons to select the
OSC period. The choices are 0:30 (30
mins), 1:00 (1 hr), 1:30 and 2:00.
The recommended setting is 0:30. If set
to 0:00 the function is disabled.
Accepting the preset programmes
If you are happy to use the preset programmes on page 7,
you don't need to do anything else. To accept these settings
just close the front cover and after 2 minutes the pre-settings
will automatically be accepted.
8