3W 112i QS 매뉴얼 - 페이지 5

{카테고리_이름} 3W 112i QS에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3W 112i QS 20 페이지.

112i B4 / QS Engine Manual

Engine Installation

The engine should be mounted on a motor box that will in turn mount to the fuselage. A quadrilateral

shape (gradually increasing in size as it goes away from the motor) provides the best circulation

of air. The reason for using a motor box rather than mounting the engine directly to the fuselage

is that the cylinder(s) need enough room around them to provide proper airflow over and away

from them

The motor box should be stiff enough to prevent engine vibration and it should also have a solid

firewall. The firewall of the motor box should be made from 1/4" aircraft plywood for engines up

to 106cc, or 3/8" aircraft plywood for engines in the 150cc class. For builders experienced with

making composite motor boxes; a comparable strength should be attained.

It is absolutely vital to ensure a tension free mounting of the engine. The surface that the engine

is mounted on must be on an even plane (i.e., a flat and level surface) so that there is no strain

on the engine itself. Again, this is a vital and critical requirement to avoid distorting the crank case,

ruining the engine, and voiding your warranty.

Mount the engine to the motor box with high tensile bolts. Once mounted you now have a sub-

assembly that you can mount to your fuselage. Spacers can be made from hardwood dowels (3/4"

to 1") or machined aluminum bar stock to adjust your down and side thrust. These spacers should

go between the motor box and fuselage and not the motor box and engine.

more infos: www.3w-modellmotoren.com