3W 170xi TS 매뉴얼 - 페이지 8

{카테고리_이름} 3W 170xi TS에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3W 170xi TS 20 페이지.

Ignition

Consideration needs to be given to the placement of the electronic ignition module. Avoid placing

the module in the path of hot air. Mount the ignition module using the four supplied rubber grommets

so as to create a 1/16" gap between the ignition module and the mounting surface. Without this

1/16" gap the ignition module can overheat. Important: If the electronic ignition overheats it will

malfunction (e.g., backfiring or shutting down).

Ignition details:

•

The red cable is positive (+)

•

The ignition timing has been set at our factory

•

When fitting a new ignition it is important to achieve the correct coordination of the sensor(s)

to the magnets

Canister mufflers

To prevent damage to the header(s) a flexible support bracket is required to mount the canister(s).

The location for this bracket should be at the canister's center of gravity. 3W canisters have a

reinforcement ring at this location.

We suggest creating two compartments in the front section of the fuselage by installing a horizontal

3W 170xi B2 / TS / CS Engine Manual

Refer to our special ignition description for further information

more infos: www.3w-modellmotoren.de