Dunham-Bush System LST 설치 지침 매뉴얼 - 페이지 9
{카테고리_이름} Dunham-Bush System LST에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dunham-Bush System LST 16 페이지.
페이지 인쇄System LST Installation - First Fix
Mark positions of fixings on the wall using the back plate as a template. Note: recommended fixing height of
100mm above FFL (Style A), styles B, C & D can be fixed at FFL or onto pipe boxing/trunking. There are a
large number of holes provided, as minimum we recommend fixing to every fourth hole along the top and
bottom edges plus 2 to 3 fixings down the sides.
B
A
C
A
B
C
C
B
A
A
C
B
Diagram 1
Drill holes to take the fixings in the wall and insert suitable wall plugs or anchors (by others).
Screw the back plate to the wall using the top and bottom rows of screws holes only excluding the corners
("A" in diagram 1 above). The side screw holes "B" are used for fixing the side plates and can be prepared
ready but are not required at this stage. Alternatively the larger holes "C" may be used as these can be drilled
and wall plugs or anchors affixed into them after the back plate has been fixed.
X
Z
X
Diagram 2
Using a large flat-bladed screw driver fold out the emitter brackets "X". If the convector is to have a fitted
internal TRV the phial brackets "Z" will also need to be folded out. See diagrams 2a & 2b for details on which
brackets to fold out for each emitter.
Page 9 of 16