Danfoss VLT AQUA Drive FC 202 설치 매뉴얼 - 페이지 13

{카테고리_이름} Danfoss VLT AQUA Drive FC 202에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss VLT AQUA Drive FC 202 20 페이지. Igbt module replacement for d1h–d8h drives
Danfoss VLT AQUA Drive FC 202에 대해서도 마찬가지입니다: 운영 매뉴얼 (16 페이지), 설치 지침 매뉴얼 (6 페이지), 설치 매뉴얼 (18 페이지), 설치 지침 매뉴얼 (8 페이지), 설치 지침 매뉴얼 (10 페이지), 설치 매뉴얼 (6 페이지), 사용 설명서 (16 페이지), 설치 지침 매뉴얼 (6 페이지), 설치 매뉴얼 (8 페이지), 설치 지침 매뉴얼 (6 페이지), 설치 매뉴얼 (8 페이지), 설치 매뉴얼 (6 페이지)

Installation

3.7.4 Wiring Procedures

Wiring procedure for enclosure sizes A1–A3

Mount the fieldbus connector on the fieldbus

option (terminals 62, 63, 66, and 67). For top

cable entry, mount the supplied EMC bracket on

top of the frequency converter with 2 screws.

Prepare the fieldbus cable by stripping a section

of the cable insulation, so that the cable screen is

in contact with the EMC bracket. Keep the

unshielded wire as short as possible. For cable

specifications, refer to chapter 3.7.2 Cable Specifi-

cations. For fieldbus cable requirements, see

chapter 3.7.3 Bus Segment Requirements.

Connect the fieldbus cable wires to the terminals

according to the colour code of the wires, see

Illustration 3.10.

To establish mechanical fixation and electrical

contact between cable screen and ground,

position the stripped cable between the spring

loaded metal clamps.

1 Cable screen

2 EMC bracket (used for top cable entry only)

Illustration 3.9 Wiring for Enclosure Sizes A1–A3

MG33C602

Installation Guide

66 and 67 5 V DC supply, available for external termination

Illustration 3.10 Fieldbus Cable Terminal Connections

62 63 66

RxD / TxD

+5 V

RxD / TxD

0 V

RxD/TxD-P red cable

RxD/TxD-N green cable

Control select, 5 V DC indicates transmission from the

fieldbus option