Danfoss APP 21-43 분해 및 조립 지침 - 페이지 4

{카테고리_이름} Danfoss APP 21-43에 대한 분해 및 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss APP 21-43 14 페이지. Disassembling and assembling
Danfoss APP 21-43에 대해서도 마찬가지입니다: 서비스 매뉴얼 (20 페이지)

페이지 인쇄

Instruction

Disassembling and assembling APP 21-43

8. Using a 13 mm combination wrench, remove

all the bolts on the mounting flange except

the three shown in picture 9.

WARNING:

Do not loosen the two screws keeping

swash plate in place.

10. Screw the eye bolt in the M8 hole in the

middle of the flange. Pull it straight upwards.

12. Remove by hand the pistons one by one.

Be careful not to scratch the pistons. Tilt the

retainer plate to horizontal position for easy

removal of pistons, if required.

WARNING:

Do not use any tools.

180R9121 / 521B1018 / DKCFN.PI.013.A4.02 / 10.2013

9. Unscrew the remaining three bolts. Turn each

bolt one round at the time to make sure that

the flange is removed as straight forward as

possible.

11. Swash plate must be placed so that its surface

is not scratched. For further disassembling of

swash plate, see page 10.

13. Remove the retainer plate and the retainer

ball.

Note: As the retainer ball is not attached to

the retainer plate, it might fall out.