Danfoss APP 3.5 분해 및 조립 지침 - 페이지 7

{카테고리_이름} Danfoss APP 3.5에 대한 분해 및 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss APP 3.5 12 페이지. Changing shaft seal
Danfoss APP 3.5에 대해서도 마찬가지입니다: 사용 설명서 (8 페이지), 매뉴얼 (5 페이지)

페이지 인쇄
Danfoss APP 3.5 분해 및 조립 지침
Service guide | Disassembling and Assembling, APP 1.5-3.5

2. Change of shaft seal

© Danfoss | DCS (im) | 2017.08
Tools needed
3. Fit the hollow bush (torpedo) to the shaft.
Wet the torpedo and replacement shaft
seal with soap. Do not use silicone
grease.
Recessed
screws
1. Unscrew the 4 mounting screws and
remove the seal SAE flange.
Do not unscrew the 2 recessed screw at
this time.
2. Wet the shaft and shaft seal with
clean (filtered) soap-water. Gently lever
the shaft seal assembly free with the aid of
2 screwdrivers.
4. Slide the shaft seal over the torpedo with
the carbon seal face pointing upwards. Be
careful not to damage the carbon seal
face on the shaft seal.
180R9091| DKCFN.PI.013.EF5.02 | 521B0741| 7
Recessed
screws