Dunkirk EXCELSIOR EXB6130 추가 지침 - 페이지 4

{카테고리_이름} Dunkirk EXCELSIOR EXB6130에 대한 추가 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Dunkirk EXCELSIOR EXB6130 20 페이지. Direct vent high efficiency oil-fired hot water boiler

페이지 인쇄

Vent Terminal Location

See table 1 for equipment certified for use with this

appliance.

Select location of wall penetration that conforms to code for

exterior location:

As close to appliance as possible,

Maintains clearance to combustibles,

Maintains minimum 1/4 inch per foot slope back to

appliance.

Install vent terminal in wall having minimum thickness

of 5", and maximum thickness of 10".

Vent Terminal Installation

• Cut a 6-1/2" diameter hole through the wall.

• Remove Intake Air Sleeve from Terminal.

• Insert Terminal through the wall from outside, secure

with 4 screws to the wall, and seal to wall with

weatherproof sealant.

• From inside the building, re-attach Intake Air Sleeve and

secure inner sleeve to outer sleeve with 2 screws.

• Use 4 screws to secure Sleeve to wall. See Figure 4.

• Insure Intake Air Connector is located for easy attach-

ment and complies with code.

Vent Terminal Riser Kit

Kit is designed to increase height of vent terminal by

approximately 3 feet.

Ideal where excessive snow build up could occur or where

more flexibility is required to maintain minimum clearances

at grade. See figure 5.

VENT TERMINAL INSTALLATION

Figure 4 - Inside View of Vent Terminal

Figure 5 - Vent Terminal Riser

P/N 240009355, Rev. C [11/15/2015]