Danfoss APP series 서비스 매뉴얼 - 페이지 7
{카테고리_이름} Danfoss APP series에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss APP series 12 페이지. Disassembling and assembling
Danfoss APP series에 대해서도 마찬가지입니다: 서비스 매뉴얼 (12 페이지), 분해 및 조립 지침 (12 페이지), 지침 (10 페이지)
페이지 인쇄
Service guide | Disassembling and Assembling, APP 0.6-1.0
3. Change of shaft seal
© Danfoss | DCS (im) | 2017.08
5. Mount flushing valve by pressing it into
the hole.
Tools needed
6. It must be pressed down so it levels with
the surface of the port flange (same level).
In order to find out if the valve is
working correctly, the pump needs to
be further dismantled. To work correctly
a small flat edged wire is pushed against
the flushing valve. You should be avle to
move it a couple of mm and feel the load
of the spring pressing backwards.
Recessed
screws
1. Unscrew the 4 mounting screws and
remove the seal SAE flange.
Do not unscrew the 2 recessed screw at
this time.
2. Wet the shaft and shaft seal with
clean (filtered) soap-water. Gently lever
the shaft seal assembly free with the aid of
2 screwdrivers.
180R9092| DKCFN.PI.013.EC5.02 | 521B0739| 7
Recessed
screws