Danfoss APP series 서비스 매뉴얼 - 페이지 5

{카테고리_이름} Danfoss APP series에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss APP series 12 페이지. Disassembling and assembling
Danfoss APP series에 대해서도 마찬가지입니다: 서비스 매뉴얼 (12 페이지), 분해 및 조립 지침 (12 페이지), 지침 (10 페이지)

페이지 인쇄

Service guide | Disassembling and Assembling, APP(W) 5.1-10.2

2. Assembling the pump

Important: It is essential that the pump is

serviced in conditions of absolute cleanliness.

1. When mounting the port plate position

the port plate over the guide pin.

IMPORTANT: Make sure that the guide pin

is located in the locating hole in the port

plate.

3. Fit the retainer guide onto the shoulder of

the shaft.

4. Carefully position all the pistons into the

retainer plate.

6. Position the new white stop bush on top

of the retainer guide.

WARNING: Do not reuse disassembled O-ring

or shaft seal as they might be damaged.

Guide pin

2. Carefully slide the cylinder barrel into the

housing.

5. Position all the pistons, one in each piston

bore, in the cylinder barrel. It may be

necessary to tilt the retaining ring to allow

the pistons to fit into the piston bores.

7. Mount the new shaft seal following the

instructions in chapter 5 see page 8-11.

180R9238 | DKCFN.PI.078.F3.02 | 521B1196 | 5