Danfoss APP series 분해 및 조립 지침 - 페이지 6

{카테고리_이름} Danfoss APP series에 대한 분해 및 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss APP series 12 페이지. Disassembling and assembling
Danfoss APP series에 대해서도 마찬가지입니다: 서비스 매뉴얼 (12 페이지), 서비스 매뉴얼 (12 페이지), 지침 (10 페이지)

페이지 인쇄

Disassembling and Assembling, APP 1.5-3.5

Service guide |

6 | 180R9091 | DKCFN.PI.013.EF5.02 | 521B0741

19. Position the new spring, new spring guide,

new retainer guide, new retainer plate and

new pistons.

21. Hold the pump together and carefully

turn it over to rest on the housing. To

prevent seizing-up, lubricate the threads

on the w screws and screw them into the

port flange and he housing. Use Molykote

D paste from Dow Corning or Klüber

UH1 84-201 from Klüber lubrication.

Tighten the 2 flange screws ato a torque

ccording to exploded view.

23. Replace the O-ring on the SAE flange.

20. Position the housing on the port flange

and over the guide pin.

22. Mount the new shaft seal following the

instructions on the next pages.

Wet torpedo and new shat seal with

soap. Do not use silicone grease.

Slide the shat seal over the torpedo with

carbon seal free face pointing upwards. Be

careful not to damage the carbon seal

facon on the shaft seal.

24. Lubricate the threads on the 4 screws

with grease and screw them into the

pump and tighten by hand. Use Molykote

D paste from Dow Corning or Küber UH1

84-201 from Küber Lubrication.