Dunkirk EXCELSIOR Series 지침

{카테고리_이름} Dunkirk EXCELSIOR Series에 대한 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Dunkirk EXCELSIOR Series 4 페이지. Oil fired boiler, knockdown assembly

This assembly must be completed by a qualified installer or service agency, in accordance with the

manufacturer's instructions, and in accordance with all codes and requirements of the authority having

jurisdiction. Failure to follow these instructions could result in fire or explosion resulting in property dam-

Remove all components from crate. It may be to the

installer's advantage to place the cast iron boiler block

close to where the final installation location will be.

Install rubber grommets in rear top plate. Attach top

and bottom plates to boiler with brass bolts and wash-

ers. Be sure top flanges point toward the front of the

boiler or the top panel will not fit on the boiler. See

Figure

Figure 1

KNOCKDOWN ASSEMBLY

Instructions for

Excelsior oil Fired Boiler

age, personal injury, or loss of life.

WARNING

Wrap insulation around boiler with the backing side

out. Wrap 2 banding strips around insulation. Cinch

banding together with plastic buckles provided. See

2. Cut off excess banding material.

Figure

Insulation straps with buckles

Attach pipe nipples to supply and return outlets. Be

sure to use pipe dope before screwing into boiler.

P/N 240007210, Rev. A [04/08]

Figure 2