3Ware 3WARE 9650SE 사양 - 페이지 7

{카테고리_이름} 3Ware 3WARE 9650SE에 대한 사양을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Ware 3WARE 9650SE 7 페이지. Remote battery board
3Ware 3WARE 9650SE에 대해서도 마찬가지입니다: 사용자 설명서 부록 (1 페이지), 사용자 설명서 (11 페이지), 설치 매뉴얼 (4 페이지)

페이지 인쇄

Using the AMCC 3ware® I2C Multiplexer with a Supermicro® Backplane

Jumper Settings for Supermicro 846TQ

Table 5: Reset Chip Settings

These jumpers control the AMI 9072 chips

Jumper

Jumper Settings

JP35

Open: No Reset (Default)

Closed: Reset

JP50

Open: No Reset (Default)

Closed: Reset

JP129

Open: No Reset (Default)

Closed: Reset

Table 6: I2C Setting (Default)

This jumper controls the I2C and SGPIO settings for the 846TQ

Jumper

Jumper Settings

JP84

2-3

all trademarks of AMCC. Supermicro® is a registered trademark of Supermicro Computer, Inc. All other trademarks herein are property of their respective owners.

While every attempt is made to make this document as accurate as possible, AMCC assumes no responsibility for errors or omissions in the document and shall not be responsible

or liable for any and all damages, claims and/or disputes that arise from dependence on this publication.

www.3ware.com

Note

This is a 2-pin jumper block.

Jumper should be removed.

This is a 2-pin jumper block.

Jumper should be removed.

This is a 2-pin jumper block.

Jumper should be removed.

Note

Jumper should connect pins 2 and 3.

Cable Pin Definitions

Table 7: Cable pins - I2C MUX to 9650SE or 9550SXU

Signal

3ware 9650SE or 9550SXU

C MUX

Reset (SB4)

Pin 3

Ground (SB2)

Pin 4

SDA (SB1)

Pin 5

Ground (SB3)

Pin 6

SCL (SB0)

Pin 7

IRQ

Pin 9

Table 8: Cable pins - I2C MUX to Supermicro backplane

Signal

Supermicro 836TQ

C MUX

SDA

Pin 1

Ground

Pin 2

SCL

Pin 3

Not Connected

Pin 4

For additional information about using the enclosure services of your

Supermicro Backplane, please consult the documentation that came

with your chassis or backplane.