Danfoss PAHT Series 분해 및 조립 지침 - 페이지 9

{카테고리_이름} Danfoss PAHT Series에 대한 분해 및 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss PAHT Series 20 페이지. Paht and paht g 256-308 disassembling and assembling
Danfoss PAHT Series에 대해서도 마찬가지입니다: 서비스 매뉴얼 (20 페이지), 지침 (20 페이지)

페이지 인쇄
Danfoss PAHT Series 분해 및 조립 지침
Service guide | Disassembling and assembling PAH 10-12.5, PAHT 10-12.5 and PAHT G 10-12.5
3.

Assembling

1. Remove swash plate and guide pin.
WARNING:
Do not use silicone when assembling the
pump. Do not reuse disassembled O-rings;
they might be damaged. Always use new
O-rings.
1. Lubrication:
• To prevent seizing-up, lubricate all
threads with PTFE lubrication type.
• O-rings inside pump may be lubricated
only with clean filtered water.
• O-rings for port flange, mounting flange
and flushing valve must be lubricated.
• It is important to lubricate ALL parts to
be assembled with clean filtered water
(Especially all PEEK parts).
180R9095 | 521B0986 0 | DKCFN.PI.010.NA4.02| 06.2017
Guide pin
Important:
It is essential that the pump is serviced in
conditions of absolute cleanliness. All parts
must be absolute clean before mounting.
2. Parts and tools required for assembly.
Check that all parts are OK. Replace all
seals.
9