Dunlop DVP5 올인원 빠른 시작 매뉴얼 - 페이지 5

{카테고리_이름} Dunlop DVP5에 대한 올인원 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dunlop DVP5 5 페이지. Low friction band-drive

페이지 인쇄
Dunlop DVP5 올인원 빠른 시작 매뉴얼

GENERAL OPERATION

POWER
The Dunlop Volume (X)
™
does not require a power source to operate.
DIRECTIONS
We recommend placing the DVP5 at the beginning of
your effects signal chain. Run a cable from your guitar
to the DVP5's INPUT jack.
Optional: Run a cable from the TUNER output
to a tuner. Signal to tuner is active regardless
of rocker position.
VOLUME MODE
Run a cable from the DVP5's OUTPUT jack to your
•
amplifier.
With the pedal in full toe-down position, set your
•
guitar and amp's maximum desired volume level.
Move the rocker pedal toward the heel-down position
•
to decrease the volume.
The output signal will be muted when the rocker
•
pedal reaches full heel-down position.
DVP5 | VOLUME (X)8 PEDAL
8 Pedal is a passive unit and
(250 kΩ POT)
EXPRESSION MODE
Run a stereo or TRS cable from the DVP5's FX jack
•
to your effects pedal's EXP jack.
With the pedal in full toe-down position, set the
•
effect parameter you want to control to the desired
maximum level.
Optional: To set the effect parameter's minimum
•
level, use internal potentiometer toward the front
of the pedal. Turn it clockwise to raise the minimum
level or counterclockwise to lower it. Note: factory
setting is fully counterclockwise.
Move the rocker pedal toward the heel-down
•
position to lower the value of the effect parameter
within the range set by your effect pedal's control
and the DVP5's internal potentiometer.
When the rocker is fully heel-down, the effect
•
parameter will be at the minimum value as set
by the internal potentiometer.
Optional: Use the internal blue push switch to
•
reverse the function of heel-and toe-down postion.
ADJUSTABLE TORQUE
To adjust rocker pedal torque, place pedal in toe-
down position. Insert a 1/4" flat blade screwdriver
into torque adjust screw located under heel-end of
rocker pedal. Turn clockwise to increase resistance
or counterclockwise to decrease resistance.
(10 kΩ POT)
5