Dunlop EJF1 ERIC JOHNSON SIGNATURE FUZZ FACE 사용자 설명서 - 페이지 3

{카테고리_이름} Dunlop EJF1 ERIC JOHNSON SIGNATURE FUZZ FACE에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dunlop EJF1 ERIC JOHNSON SIGNATURE FUZZ FACE 4 페이지.

EJF1 ERIC JOHNSON SIGNATURE FUZZ FACE

DIRECTIONS

• Run a cable from your guitar to

the Fuzz Face's Input jack and run

another cable from the Fuzz Face's

Output jack to your amplifier.

• Set the Fuzz Face's controls to their

12 o'clock position.

• Turn the effect on by depressing

the footswitch.

• Dial in the amount of desired fuzz by

adjusting the FUZZ knob.

• Use the LEVEL knob to set the

desired volume level of the effect.

• Try rolling back your guitar's volume

knob to clean up the Fuzz Face.

CONTROLS

• Footswitch toggles effect on/ bypass

• Volume knob controls total

output level

• Fuzz knob controls intensity of the

fuzz tone

POWER REQUIREMENTS

The EJF1 Eric Johnson Fuzz Face

requires one 9 volt battery. Unscrew

the bottom of the pedal to access the

battery clip. Remove the instrument

cable from the input jack when not in

use to extend battery life.

SPECIFICATIONS

Input Impedance

Output Impedance @ 1 kHz

Maximum Gain

Current Draw

500 uA @ 9 VDC

Bypass

True Hardwire Bypass

*All specifications are measured at 1 kHz

10 k

16 kΩ

55 dB