Danfoss 176F4193 설치 매뉴얼 - 페이지 15
{카테고리_이름} Danfoss 176F4193에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss 176F4193 16 페이지. In-bottom/out-back cooling kit for fa11-fa12, frequency converters
페이지 인쇄
In-bottom/Out-back Cooling Kit for FA11-FA12
Installation Guide
2.11 Installing the Backplate and Back Duct
To attach the cabinet backplate and the back duct, use the following steps.
Procedure
1.
Position the backplate on the back rails of the cabinet behind the mounting plate.
2.
Secure the backplate to the rails using the existing fasteners.
3.
Slide 8 M5 clip-on nuts over the screw holes around the duct opening in the backplate.
4.
Remove the paper backing from both 8-hole gaskets, exposing the adhesive.
5.
Adhere 1 gasket to the back and 1 gasket to the front of the back duct outer flange.
6.
Position the back duct in the hole created for it in the mounting plate and backplate.
7.
Fasten the inner flange of the back duct with 6 M6x12 screws (T30).
Torque to 3.9 Nm (35 in-lb).
8.
Fasten the outer flange of the duct with 8 M5x18 screws (T25).
Torque fasteners to 2.3 Nm (20 in-lb).
Danfoss A/S © 2022.12
Installation
AN361429392581en-000201 / 136R0253 | 15