Danfoss iC7 Series 설치 매뉴얼 - 페이지 5

{카테고리_이름} Danfoss iC7 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss iC7 Series 8 페이지. In-bottom/out-back cooling kit for fa09-fa10, frequency converters
Danfoss iC7 Series에 대해서도 마찬가지입니다: 설치 매뉴얼 (8 페이지), 설치 매뉴얼 (8 페이지), 설치 매뉴얼 (6 페이지), 설치 매뉴얼 (14 페이지), 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (8 페이지), 설치 매뉴얼 (10 페이지), 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (6 페이지), 설치 매뉴얼 (6 페이지), 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (18 페이지)

Pedestal Kit for FK09/FB09 and FK10/FB10

Installation Guide

Fasten 2 M5 screws through the back flange of the pedestal base into the flange on the lower end of the frequency con-

verter.

To secure the frequency converter to the wall or mounting panel, fasten 2 M10 bolts (not supplied) in the mounting holes

at the top of the frequency converter. Use 1 bolt per mounting hole.

Illustration 3: Pedestal-to-Frequency Converter Mounting Points

M5 screw in back flange

M10 nut

2.6 Creating Cable Openings

The cable entry plate provides cable entry and cable termination points, and must be installed to maintain the IP21/Type 1 or IP54/

Type 12 protection rating. The cable entry plate is placed between the frequency converter cabinet and the pedestal. Reuse the

cable entry plate that is shipped with the frequency converter.

The cable entry plate can be installed from inside the frequency converter cabinet or before attaching the front cover and side

plates of the pedestal. To install the cable entry plate, use the following steps. Refer to

Create cable entry holes in the plate using a sheet metal punch.

Insert the cable entry plate using 1 of the following methods:

Illustration

AN371942906358en-000101 / 136R0256 | 5

Installation