Danfoss iC7 Series 설치 매뉴얼 - 페이지 9

{카테고리_이름} Danfoss iC7 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss iC7 Series 16 페이지. In-bottom/out-back cooling kit for fa09-fa10, frequency converters
Danfoss iC7 Series에 대해서도 마찬가지입니다: 설치 매뉴얼 (8 페이지), 설치 매뉴얼 (8 페이지), 설치 매뉴얼 (6 페이지), 설치 매뉴얼 (14 페이지), 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (8 페이지), 설치 매뉴얼 (8 페이지), 설치 매뉴얼 (10 페이지), 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (6 페이지), 설치 매뉴얼 (6 페이지), 설치 매뉴얼 (18 페이지)

In-back/Out-back Cooling Kit for FA09-FA10

Installation Guide

Illustration 7: Installation of the Top Cover

M5x14 screws

Top cover

2.6 Mounting the Frequency Converter

To install the mounting plate and frequency converter in the Rittal cabinet, use the following steps. Refer to

Procedure

Remove the backing paper from the 2 self adhesive upper mounting plate gaskets.

Affix the gaskets around the upper opening, 1 on each side of the mounting plate.

Remove the backing paper from the 2 self adhesive lower mounting plate gaskets.

Affix the gaskets around the lower opening, 1 on each side of the mounting plate.

Attach the mounting plate to the cabinet rails, making sure that the pem studs face the front of the cabinet.

Remove the backing paper from the 2 seal plate gaskets.

Affix the gaskets to the seal plates, 1 per plate.

Fasten 2 M10x30 screws through the seal plates, 1 per plate, and into the M10 nuts at the lower end of the mounting plate.

Check that the screws are secure. The base of the frequency converter rests on the screws.

Slightly lean the top of the frequency converter forward and set the notches in the base onto the 2 screws.

10.

Slowly push the top of the frequency converter back against the mounting plate until the top 2 pem studs line up with the

holes in the frequency converter.

11.

Secure the top of the frequency converter using 2 M10 nuts.

Torque all fasteners to 19 Nm (170 in-lb).

Top cover gasket

Top vent

AN371942471353en-000101 / 136R0248 | 9

Installation

Illustration