Casio CFX-9850G PLUS 커뮤니케이션 매뉴얼 - 페이지 10

{카테고리_이름} Casio CFX-9850G PLUS에 대한 커뮤니케이션 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Casio CFX-9850G PLUS 13 페이지. 6. matrix calculations
Casio CFX-9850G PLUS에 대해서도 마찬가지입니다: 사용자 설명서 (18 페이지), 프로그램 매뉴얼 (18 페이지), 첫 번째 매뉴얼 읽기 (13 페이지), 기능 설명서 (14 페이지), 그래프 매뉴얼 (8 페이지), 그래프 매뉴얼 (6 페이지), 그래프 매뉴얼 (12 페이지), 그래프 매뉴얼 (12 페이지), 그래프 매뉴얼 (12 페이지), 그래프 매뉴얼 (12 페이지), 그래프 매뉴얼 (10 페이지), 계산 매뉴얼 (13 페이지), 계산 매뉴얼 (18 페이지), 계산 매뉴얼 (15 페이지), 복소수 매뉴얼 (6 페이지), 계산 매뉴얼 (6 페이지), 계산 매뉴얼 (20 페이지)

21-6 Screen Send Function

The following procedure sends a bit mapped screen shot of the display to a

connected computer.

u u u u u To send the screen

P.402

1. Connect the unit to a personal computer or to a CASIO Label Printer.

2. In the data communication main menu, press 6 (IMGE) and the following

P.403

CFX

fx-9750G

PLUS

3. Press a function key to specify either "Monochrome" or "Color" for the Image

CFX

4. Display the screen you want to send.

5. Set up the personal computer or Label Printer to receive data. When the other

P.403

CFX

You cannot send the following types of screens to a computer.

408

display appears.

• {OFF} ... {graphic images not sent}

• {MONO}/{COLR} ... {monochrome}/{color} bitmap

• {ON} ... bitmap

Set Mode.

unit is ready to receive, press M to start the send operation.

• Selecting "Monochrome" for Image Set allows data to be sent to any CASIO

Label Printer equipped with data communications capabilities.

Selecting "Color" allows data to be sent to Color Label Printer models only.

• The screen that appears while a data communication operation is in progress.

• A screen that appears while a calculation is in progress.

• The screen that appears following the reset operation.

• The low battery message.

• The flashing cursor is not included in the screen image that is sent from the

unit.

• If you send a screen shot of any of the screens that appear during the data

send operation, you will not be able to then use the sent screen to proceed

with the data send operation. You must exit the data send operation that

produced the screen you sent and restart the send operation before you can

send additional data.

• You cannot use 6mm wide tape to print a screen shot of a graph.

* The above shows the CFX-9850

GB PLUS screen.