Airwell AW-WHPMA06-91 설치 및 설정 - 페이지 6

{카테고리_이름} Airwell AW-WHPMA06-91에 대한 설치 및 설정을 온라인으로 검색하거나 PDF를 다운로드하세요. Airwell AW-WHPMA06-91 15 페이지.

DIP Switch Settings

There are 3 sets of dip switch located on the unit's main PCB, these are S1, S2, S3 these control certain function of the

unit, so must be set accordingly to allow correct operation.

S1 Dip Switch's control the IBH if fitted in the unit.

S2 Dip Switch's control the Internal Pump.

S4 Dip Switched are for multiple unit setups.

S1 Dip switch 1/2 should be set to OFF/OFF, this will deactivate the IBH (internal back up heater is not fitted to the

Airwell unit as standard)

S1 Dip switch 3/4 should be set to

OFF/OFF,

this will deactivate the IBH and AHS (additional heat Source) if fitted set to

OFF/ON

S2 Dip switch 1 should be

OFF

S2 Dip switch 2 should be set to

OFF

if the immersion heater is connected to the unit. If the Immersion heater is

independent from the heat pump this must be set ON, failure to do so will lead to faults.

S2 Dip switch 3/4 should be set according to the pump installed in the unit.

S4 Dip switch 1/2/3/4 all off as Default.

W: www.aukdistribution.com

T: 0191 516 6553