Danfoss VLT AutomationDrive FC 301 설치 매뉴얼 - 페이지 12

{카테고리_이름} Danfoss VLT AutomationDrive FC 301에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss VLT AutomationDrive FC 301 16 페이지. 24 v dc supply
Danfoss VLT AutomationDrive FC 301에 대해서도 마찬가지입니다: 설치 매뉴얼 (20 페이지), 설치 지침 매뉴얼 (6 페이지), 설치 매뉴얼 (18 페이지), 설치 지침 매뉴얼 (8 페이지), 설치 매뉴얼 (6 페이지), 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (8 페이지), 설치 지침 매뉴얼 (6 페이지)

페이지 인쇄
Danfoss VLT AutomationDrive FC 301 설치 매뉴얼
Installation
Wiring procedure for enclosure sizes D, E, and F
1.
Mount the fieldbus connector on the fieldbus
option (CAN_L, Drain, CAN_H).
2.
Prepare the fieldbus cable by stripping a section
of the cable insulation. Keep unshielded wire as
3
3
short as possible. For cable specifications, refer to
chapter 3.7.1 Cable Specifications.
3.
Connect the fieldbus cable wires to the terminals
according to the colour code of the wires, see
Illustration 3.6.
4.
Fix the cable screen to the metal base plate using
cable clamp or cable tie, see Illustration 3.9.
5.
Tie down the cable and route it with other
control wires inside the unit, see Illustration 3.9.
Illustration 3.9 Wiring for Enclosure Sizes D, E, and F
10
®
VLT
CANopen MCA 105

3.8 Reassembling Cover

1.
2.

3.9 Applying Power

Follow the instructions in the frequency converter
operating instructions to commission the frequency
converter. The frequency converter automatically detects
the CANopen interface. A new parameter group (Group 10)
appears.

3.10 Checking Network Cabling

1.
2.
3.
Danfoss A/S © 05/2015 All rights reserved.
Mount the new front cover and the LCP.
Attach the sticker with the correct product name
to the front cover.
If the address has not been set via the address
switches, go to parameter 10-02 MAC ID to set the
address.
Connect to a running CANopen master.
Check that network cabling is correct or not.
MG33J402