Danfoss VLT FC 103 설치 지침 매뉴얼 - 페이지 6

{카테고리_이름} Danfoss VLT FC 103에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss VLT FC 103 6 페이지. Igbt module replacement for d1h–d8h drives
Danfoss VLT FC 103에 대해서도 마찬가지입니다: 운영 매뉴얼 (16 페이지), 설치 매뉴얼 (20 페이지), 설치 매뉴얼 (18 페이지), 설치 지침 매뉴얼 (8 페이지), 설치 지침 매뉴얼 (10 페이지), 설치 매뉴얼 (6 페이지), 사용 설명서 (16 페이지), 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (8 페이지), 설치 지침 매뉴얼 (6 페이지), 설치 매뉴얼 (6 페이지)

페이지 인쇄
Danfoss VLT FC 103 설치 지침 매뉴얼
8.
Unscrew the 2 T10 screws holding the control card
EMC shield (4 screws if MCO is installed).
8a
If MCO is installed, remove the MCO ribbon
cable.
9.
Remove the control card EMC shield.
1
T10 screws
2
EMC shield
Illustration 1.7 Screws and EMC Shield
Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products already on
order provided that such alterations can be made without subsequential changes being necessary in specifications already agreed. All trademarks in this material are property of the respective companies. Danfoss
and the Danfoss logotype are trademarks of Danfoss A/S. All rights reserved.
Danfoss A/S
Ulsnaes 1
DK-6300 Graasten
vlt-drives.danfoss.com
130R0788
1
2
Re-assemble the new control card in reverse order.
MI93A102
*MI93A102*
10.
Unscrew the 3 T10 screws and remove them.
11.
Gently remove the control card from the upper-right
socket. Avoid overbending and contact with
electronic components.
Control card
T10 screws
Illustration 1.8 Control Card and T10 Screws
03/2017