Dunster House H3-GS3X3MK2 설치 매뉴얼 - 페이지 7

{카테고리_이름} Dunster House H3-GS3X3MK2에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dunster House H3-GS3X3MK2 18 페이지. Gazebo 3m x 3m

페이지 인쇄

Utopia 300 Gazebo 3m x 3m Installation Manual

Step 3

Components required:

Post Beam - 70x35x1603.A (4 required)

Roof Connector - 35x35x95 (1 required)

70mm Screws (8 required)

95mm Screws (4 required)

Fix the post beam (70x35x1603.A) and roof

connector (35x35x95) to the Gazebo frame.

Once the frame is assembled, fix the post beams

70x35x1603.A to the middle of

86x43x3000.C using 2x 70mm screws, so that

they are flush with each other. At the opposite end

of the post beam 70x35x1603.A attach the roof

connector 35x35x95 by screwing diagonally

through the post beam 70x35x1603.A and into

the roof connector 35x35x95 using 1x 95mm

screw.

Repeat this process until you have

all 4 post beams assembled,

the same as what is

shown in the diagram.

x2 70mm screws

Step 4

Components required:

Bottom Cap - (1 required)

50mm Screws (2 required)

Fixing the bottom cap.

In the position shown in the

diagram, fix the bottom cap

into place using 2x 50mm

screws.

bottom cap

2x 50mm screws

70x35x1603.A

Side view

35x35x95

with 2x

70x35x1603.A

removed for

clarity.

x2 50mm screws

View from underneath,

looking up.

86x43x3000.C

Step 5

Components required:

Temporay Support Post - 35x35x2325 (1 required)

Temporary support post.

To achieve the correct height for the roof, position the

bottom cap

temporary support post 35x35x2325 vertically under the

bottom cap. Leave the temporary support post

35x35x2325 in position until after the roof and roof

material have been fully installed.

70x35x1603.A

Ensure post beam &

post support edges

are all flush.

95mm screws.

35x35x95

Fix at and angle.

into the roof

section support.

35x35x95

bottom cap

35x35x2325

70x35x1603.A

35x35x2325

Page 6