Danfoss VLT Midi Drive FC 280 설치 지침
{카테고리_이름} Danfoss VLT Midi Drive FC 280에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss VLT Midi Drive FC 280 4 페이지. Fan replacement
Danfoss VLT Midi Drive FC 280에 대해서도 마찬가지입니다: 설치 지침 (2 페이지), 설치 지침 (4 페이지), 설치 지침 매뉴얼 (6 페이지), 설치 지침 (4 페이지)
페이지 인쇄
Installation Instructions
®
VLT
24 V DC Supply MCB 106
®
VLT
Midi Drive FC 280
The instructions provide information about installing the VLT
24 V DC Supply MCB 106 on VLT
®
VLT
24 V DC Supply MCB 106 is a low voltage supply to the
control card. The intended use case is to keep the fieldbus
communication of the control card active at all time during a
mains power loss or power cycle. It does not enable full
operation of the LCP (including the parameter settings)
without connection to mains. The specifications of VLT
DC Supply MCB 106 are described in Table 1.1.
Input voltage
Reversed voltage input protection
Output voltage
Output power
Input capacitance load
Power up delay
®
Table 1.1 VLT
24 V DC Supply MCB 106 Specifications
®
Midi Drive FC 280.
®
24 V
24 V DC +15%
(Maximum 37 V in 10 s)
Yes
19.9 +0.6 V
Minimum 10 W
<110 uF
<0.6 s
Danfoss A/S © 02/2019 All rights reserved.
®
1
VLT
2
Cable
3
Plug
®
Illustration 1.1 VLT
NOTICE
®
VLT
24 V DC Supply MCB 106 only supports CANopen
PROFIBUS, PROFINET, and EtherNet/IP™ variant of VLT
Drive FC 280.
®
CANopen
is a registered trademark for CAN IN
AUTOMATION international users and manufacturers group
e. V.
EtherNet/IP™ is a trademark of ODVA, Inc.
Only Danfoss authorized, qualified personnel is allowed to use
this equipment. The personnel must be familiar with the
instructions and safety measures described in the
®
VLT
Midi Drive FC 280 Operating Guide.
®
24 V DC Supply MCB 106
24 V DC Supply MCB 106 Overview
®
,
®
Midi
MI07G202