Danfoss VLT PROFIBUS DP MCA 101 설치 매뉴얼 - 페이지 6
{카테고리_이름} Danfoss VLT PROFIBUS DP MCA 101에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss VLT PROFIBUS DP MCA 101 6 페이지. In automationdrive fc 361
Danfoss VLT PROFIBUS DP MCA 101에 대해서도 마찬가지입니다: 설치 매뉴얼 (20 페이지)
페이지 인쇄
Installation Guide | VLT® PROFIBUS DP MCA 101
4.3 Wiring Procedures
Procedure
1. Mount the fieldbus connector on the fieldbus option (terminals 62, 63, 66, and 67).
2. Prepare the fieldbus cable by stripping a section of the cable insulation, so that the cable screen is in contact with the EMC bracket.
Keep the unshielded wire as short as possible. For cable specifications, refer to
3. Connect the fieldbus cable wires to the terminals according to the color code of the wires, see
CS
RxD / TxD
P
RxD / TxD
N
62 RxD/TxD-P red cable.
66 and 67 5 V DC supply, available for external termination.
Illustration 2:
Fieldbus Cable Terminal Connections
4. Fix the cable screen to the metal base plate using cable clamp or cable tie.
5. Tie down the cable and route it with other control wires inside the unit.
Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products
already on order provided that such alterations can be made without subsequential changes being necessary in specifications already agreed. All trademarks in this material are property of the respective
companies. Danfoss and the Danfoss logotype are trademarks of Danfoss A/S. All rights reserved.
Danfoss A/S
Ulsnaes 1
DK-6300 Graasten
vlt-drives.danfoss.com
Danfoss A/S © 2019.03
62 63 66
67
+5 V
0 V
*MG06M102*
MG06M102
3.2 Cable
Specifications.
illustration
63 RxD/TxD-N green cable.
CS Control select, 5 V DC indicates transmission from the
fieldbus option.
Installation
2.
AN274235331989en-000101/ 130R0855