Duo-Therm 57915.731 설치 지침 매뉴얼 - 페이지 14

{카테고리_이름} Duo-Therm 57915.731에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duo-Therm 57915.731 17 페이지. Roof top air conditioner/heat pump
Duo-Therm 57915.731에 대해서도 마찬가지입니다: 설치 및 운영 지침 매뉴얼 (17 페이지)

페이지 인쇄

Installing unit with 3105007.XXX or 3105935.XXX Re-

turn Air Cover - Continued from page 13, column A.

3. Place divider plate up to bottom of air conditioner/

heat pump base pan firmly. The foam tape on the

divider plate must seal to bottom of base pan. See

FIG. 14A.

Note: The adhesive on the insulation is extremely

CAUTION

Improper installation and sealing of divider

plate will cause the compressor to quick

cycle on the cold control. This may result in

fuse or circuit breaker opening and/or lack of

cooling.

FIG. 14A

sticky. Be sure the part is located where desired

before pressing into place.

4. With slight pressure then push the divider plate

against the double sided tape on the ceiling tem-

plate.

5. Locate the 1/8" x 7" x 18" self -adhesive insulation

supplied with the return air kit. Remove the backing

paper from the insulation and carefully stick onto

the ceiling template divider panel. See FIG. 15A.

a. Excess width is intended to seal the divider plate

to the sides of the 14-1/4" x 14-1/4" (±1/8")

opening. This is to help prevent cold air discharge

from circulating into the air conditioner/heat

pump return air opening.

b. If the insulation is too high, stick excess height

of insulation to the air conditioner/heat pump

base pan. Do not cover up unit rating plate.

FIG. 15A

ANALOG DUCTED INSTALLATION INSTRUCTIONS

Installing unit with 3308120.XXX Genesis Air Filtration

System Return Air Kit Return Air Cover - continued from

page 13, column B.

4. Use Aluminum foil tape (not supplied) to seal the

ends of the foam divider to the sides of the opening.

Make sure the area behind the flange on the ceiling

template is sealed. See FIG. 14B.

Use Aluminum Foil Tape To Seal the

FIG. 14B

Foam Divider To The Sides of 14-1/4"

x 14-1/4" (±1/8") Ceiling Opening

Route wires

through Slot

Catch Flange In Groove Of

Return Air Cover

Make Sure To Seal

Behind Flange