Duo-Therm 59516.631 설치 지침 매뉴얼 - 페이지 15

{카테고리_이름} Duo-Therm 59516.631에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duo-Therm 59516.631 17 페이지. Roof top air conditioner/heat pump
Duo-Therm 59516.631에 대해서도 마찬가지입니다: 설치 및 운영 지침 매뉴얼 (17 페이지)

페이지 인쇄

11. INSTALLATION OF INSIDE DECORATIVE COVER.

Installing unit with 3105007.XXX or 3105935.XXX

Return Air Cover

A. Locate the relay control box on the ceiling template

with the white 6 connector plug on the right (curb side)

side of RV.

B. Drive two #10 x 3/8" blunt point Phillips head screws

through the ceiling template into holes in control box to

hold it in place.

C. Remove the return air grill from the return air cover.

D. Place the return air cover up to the ceiling template.

E. Install cover to template with #8 x 3/8" pointed Phillips

head screws provided (6 required).

F. Reinstall filter return air grill into return air cover. Align

tabs with mating notches and snap into place

G. Install two hole plugs into screw holes in back of return

air cover. See FIG. 16A.

FIG. 16A

Hole

Plugs

This completes the installation of the air conditioner/

heat pump. We recommend that power be supplied to

the air conditioner/heat pump and check for proper op-

eration. Refer to Operating Manual or Users Guide for a

description of the air conditioner/heat pump operation.

ANALOG DUCTED INSTALLATION INSTRUCTIONS

Return Air

Cover

Return

Air Grill

Installing unit with 3308120.XXX Genesis Air Filtra-

tion System Return Air Kit Return Air Cover

Install the slider in the return air cover and raise it to

the ceiling template. Route the wires from the return air

cover through the template slot leaving about 3" be-

tween, and position wire where they can be reached

after plastic cover is installed. See FIG. 15B. Place the

front of the return air cover against the ceiling and slide

towards the rear. The flange on the ceiling template will

catch in the groove on the return cover. Adjust the posi-

tion (right to left) and install the front two screws. In-

stall the remaining screws.

Note: Number 10 cabinet screw can be used to re-

place the two front screws to hold the plastic cover

flush to the ceiling.

1. Connect together the DC wires (3) black negative

and (3) red positive from the supply, control box and

filter indicator.

B. Insert the filter from the right side (looking toward the

RV front) over the wires. Make sure the wires are se-

cured above the filter and will stay out of its way.

Place grill on return air cover and snap in place. Decal

is on end over circuit board.

Place slide handle through slots in grill into the slide

posts. Handle will fit in either direction.

FIG. 15B

Foam

Divider

Slider

Return Air

Cover

Handle

This completes the installation of the air conditioner/

heat pump. We recommend that power be supplied to

the air conditioner/heat pump and check for proper op-

eration. Refer to Operating Manual or Users Guide for a

description of the air conditioner/heat pump operation.

Ceiling

Template

Filter

Grill