Casio FX-9750G 매뉴얼 - 페이지 9

{카테고리_이름} Casio FX-9750G에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Casio FX-9750G 16 페이지. 3. solve, differential/quadratic differential, integration, maximum/minimum value, and calculations
Casio FX-9750G에 대해서도 마찬가지입니다: 사용자 설명서 (18 페이지), 부록 (10 페이지), 매뉴얼 (12 페이지), 매뉴얼 (19 페이지), 매뉴얼 (13 페이지), 매뉴얼 (10 페이지), 매뉴얼 (12 페이지), 매뉴얼 사용 (12 페이지), 매뉴얼 (11 페이지), 매뉴얼 (14 페이지), 매뉴얼 (9 페이지), 부록 (18 페이지), 매뉴얼 (18 페이지), 매뉴얼 (17 페이지)

페이지 인쇄

k k k k k Turning Plot Points On and Off

Use the following procedures to turn specific plot points on and off.

u u u u u To turn plot points on and off in the STAT, GRAPH, TABLE, RECUR

and CONICS Modes

• To turn a plot point on

1. After drawing a graph, display the sketch menu and then perform the following

operation to make the pointer appear at the center of the screen.

!4(Sketch)6(g)1(PLOT)2(Pl•On)

2. Use the cursor keys (f, c, d, e) to move the pointer to the location where

you want to plot a point and then press w.

• To turn a plot point off

Perform the same procedure as described under "To turn a plot point on" above,

except press 3 (Pl•Off) in place of 2 (Pl•On).

• To change the on/off status of a plot point

Perform the same procedure as described under "To turn a plot point on" above,

except press 4 (Pl•Chg) in place of 2 (Pl•On).

u u u u u To turn plot points on and off in the RUN or PRGM Mode

The following are the syntax for turning plot points on and off in these modes.

• To turn a plot point on

PlotOn <

-coordinate>, <

• To turn a plot point off

PlotOff <

-coordinate>, <

• To change the on/off status of a plot point

PlotChg <

-coordinate>, <

Graphing with the Sketch Function

-coordinate>

10 - 2

181